Everyone Works

When you are not driving, in the staging area, or on break you are expected to work as a track marshal. Your times will only be recorded if you work when you are not running.

Keep the venue clean

It is very hard to find venues. We are very fortunate that Rocky Mountain Motorsports is supporting us to be able to run this event on their property. Keep it clean. What you bring in, you take out.

Bring a Helmet

Helmets must be worn by all occupants of the car while the the car is on the track.

Helmet Requirements
Helmets must be worn for all track and autocross events. Helmets certified as meeting the most current or the two most recent applicable Snell, FIA, or SFI standards are acceptable. Acceptable helmets are:

Snell ratings: SA2015, SAH2015, SA2020, SAH2020, M2015, M2020
SFI ratings 31.1, 31.1A, 3.12, 31.2A, 31.1 2005, 41.1, 41.1A, 41.2, 41.2A, 41.2 2005, 24.1
FIA Ratings: 8860-2020, 8860-2015, 8859-2015
ECE R22.05
BS6658-85 Type A/FR, BS6658-85 Type A

Winter Tires Only

Summer tires are not permitted. Cars are classed based on drive: FWD, RWD, or AWD.

Studded Winter Tires

Studded tires are not allowed on any part of the asphalt track including the pits at Rocky Mountain Motorsports. Studded tires may be used in the paved paddock only to get to start and to your paddock spot. Studded tires may be used on the competition surface. Studded tires produced by a tire manufacturer (such as the Nokian Hakkapeliitta 9) that are DOT approved for use on public roads may be used. These tires must retain the original amount and type of stud installed at time of manufacture and must not be modified.

Tires in which studs are installed subsequent to the manufacturing process may also be used and the following conditions must be met.

(a) Studs must protrude no more than 3.5mm from the tread face, and meet the Tire stud Manufacturers Index (TSMI) specifications on size 12, 13, 15 or 16. Stud construction shall have a single base flange, a cylindrical body, and carbide tip with maximum diameter of 2.5mm.
(b) The studs must be mounted in DOT tires that are designated by the manufacturer as studdable and are produced with moulded holes for the purpose of stud retention.
(c) There may only be a maximum of 130 studs per tire, regardless of tire size.
(d) Adhesive may be used to affix the stud into the tire.
(e) Homemade, competition, specialty, off road or custom studs are not permitted.

Noise / Exhaust

RMM has legal sound limitations that are enforced by the county. Noise levels above those limitations can cause serious problems, including the loss of the venue. Based on RMM's sound tests in the summer, it appears that vehicles with sound levels below 95dB should be acceptable. However, Winter AutoX is running in a different location off the track where sound levels were tested. Sound levels outside of the facility must remain below 66 dB. If our activities create sounds outside of the facility >66dB the maximum sound level for Winter AutoX will be reduced for the next event. All vehicles must have an exhaust system installed including a muffler. Sound will be measured at the event. Vehicles that are louder than 95dB will have one chance to make a mechanical change to bring the level below 95dB. If that doesn't happen, that vehicle will be refused entry or asked to leave. Keeping the noise down is extremely important.

Other Rules

You must not drive on any paved surface with the exception of the venue entrance road and paved paddock. The RMM track, entrance to the track from the pits, the exit from the track to the pits, and the pits are strictly off limits.

Waivers are Required

Fill out the waivers and tech form and either email it to david.gray@cscc.ab.ca or print and bring them to registration on the day of the event:

Vehicle Technical Self-Declaration

Personal Waiver Waiver, General_En_Autoslalom.pdf

If the entrant is under 18 years of age, two waivers need to be signed

Safety Plan:2023CSCCWinterAutoXSafetyPlan.pdf